• Driver
  • 드라이버
  •  
  • ● LBD-V Driver

    제품사양
    - Input voltage : DC 12V / 24V 
- Control type : Hall IC control type
- Output : Max 120W 
- Current : Max 10 A
- Weight : 132g
    카탈로그 보기
  • 제품사양
  • - Input voltage : DC 12V / 24V 
- Control type : Hall IC control type
- Output : Max 120W 
- Current : Max 10 A
- Weight : 132g
  • 제품상세



  •  

    - CW/CCW, brake, speed control, up to 10A, available drivers to 200W class BLDC Motor.
    - Hall sensors in DC 12v-24v
    - Control of BLDC Motor is possible
    - Can be powered from 10v.
    - Long life and high reliability in the basic specification of BLDC Motor crafted to fit as much as possible,
    enhancing the safety of the motor and driver when applied to the equipment.
    - Even third party BLDC motors can be used as a jumper setting.

     

    Pos Line color Name Description
    1 Black 10VDC Out Power supply positive for external speed setter (For External Vol.)
    2 Gray 5VDC Out DC5V/0.1A Output.
    3 Purple Vref. Speed control reference
    4 Blue GND GND for Speed setting signals
    5 Green GND GND for I/O signal
    6 Yellow F/R Direction of rotation and direction change, use Short to GND
    7 Orange Brake GND와 Open시 Bread, Short Brake 해제
    8 Red START / STOP START/STOP control
     It must be short with GND, then the motor will be stop
     H : Motor rotates L : Motor stops
    9 Brown START / STOP ON/OFF control
     It must be short with GND, then the motor will be active
     H : Motor stops L : Motor rotates
     * Lighting the FAULT(RED) led
    10 White GND GND for I/O signals

     

    Use 8 + GND or 9 + GND want the Start/Stop operation, 5(GND) + 7(BRAKE) should be the first Short.

    ex) 5, 7, and 8 this Short state -> Stop (powered standby), 5 and 7 Short, 8 open State -> Drive


     

    Pos 1 2 3 4 5 6 7 8
    Name Vcc Hall_C(W) Hall_B(V) Hall_A(U) GND W V U
    Descriptions Hall Sensor Hall Sensor Hall Sensor Hall Sensor Ground Motor W phase Motor V phase Motor U phase

     

     

    		  
   

TOP